Preparation 

Please carefully review the instructions for both Elastilon and your flooring material before starting your project. Be sure to inspect all flooring thoroughly before installation to ensure that there are no visible defects. It is the responsibility of the owner / installer to ensure that the material, the environmental and the sub-floor conditions are acceptable before the installation commences. The following instructions comply with the recommendations as outlined in the Installation Guidelines and Methods published by the National Wood Flooring Association (NWFA). Additional application information is available at www.NWFA.org

As wood is a natural product, it is important to recognize that hardwood floors will be affected by the levels of humidity and temperature within a room. The climate conditions in the room need to be maintained prior (at least 14 days), during and after the installation. The installation site must have a consistent room temperature of 60-80F (16-27C) and humidity level between 40-65% maximum (maintaining humidity levels closer to the upper range is recommended). Permanent air conditioning and heating systems need to be operational at all times. Care must be taken with wood stoves and electric heat which tend to create very dry conditions. The use of dehumidifier or humidifier depending on the situation may be necessary to maintain desired results. For complete details on how to deal with wood floors and the environment, please refer to the NWFA publications (No. A100 – Water and Wood / No. C200 -Problems, Causes and Cures).

Jobsite preparation is necessary for a proper installation. Be sure to follow the minimum jobsite recommendations listed in Section 1, Chapter 1 of the NWFA Installation Guidelines and Methods.

Is Elastilon user friendly?

Elastilon installs 50 to 70% faster than traditional glue down and other hardwood flooring installations. It requires no messy glues and their specialized spreaders, no heavy compressors and their attachments and no nailing guns. A roll of Elastilon weighs considerably less then glue down adhesive pails or, compressors and requires only a sharp knife for a perfect installation. For the end user, it does not release odors and has no VOCs. Finally, the floor can be walked on immediately after installation.

Where can Elastilon be used?

Elastilon can be used over any structurally sound subfloor or just about any existing flooring material. Lay it right over any wood, concrete, vinyl tile or sheet, ceramic, or any other FLAT stable material.  Be sure to follow the parameters in regards to maximum flatness in all cases. Do not install over any type of carpeting. Elastilon can be used in both residential and commercial applications.

Be sure to find out more about our complete line of Elastilon products including Strong, Removable, Lock and Sport. You will find an installation membrane for all your needs.

Elastilon helps to produce perfect floors!!!